Spécialiste du séchage industriel et de l'ingénierie des procédés
Drying, our main area of expertise
International expert and leader in heat transmission, hydromechanics and design of custom-made equipment and installation design
Numerical simulation
Numerical simulation of thermal flows and transfers
Our simulation software are 3D tools to bring understanding to any equipment:
- Using, moving or undergoing the effect of a fluid,
- Generating or undergoing a thermal flux,
- Subjected to stress, torsor, stress, etc.
They are therefore real tools for decision making, less expensive and faster than experimentation and allowing the determination of measureable quantities and the identification of complex phenomena.
For more than 10 years, TECHNI-PROCESS has put its industrial experience and its double engineering/ calculation competence at the service of its industrial customers to answer their most complex problems.
Flow in a VES dryer
The objective of this calculation was to provide assistance in the design and implementation of an industrial pilot of drying in superheated water vapour to validate the hypotheses of scale up.
More
Flow simulation for wind
Our flow simulation tools can predict the performance, characteristic and mechanical performance of any wind system.
More
Flow Simulation in a cyclone
The objective of this calculation was to aid in the design and construction of a cyclone separator to validate the scale up assumptions and predict the cut-off threshold.
More
Simulation of heat transfers in a disipator
Calculation of the heat transfer coefficient of an electronic radiator taking into account the fluidity, the ventilation system and the heat of the solids.
More
Simulation of the Modane wind tunnel fan
This calculation, carried out on behalf of Flaktwood and ONERA, was intended to predict the characteristics (performance curve and fan efficiency of the Modane Andrieu S1MA large wind tunnel).
More